boardinventory
This is an old revision of the document!
Table of Contents
RetroBrew Computers Board Inventory
The table below documents the approximate inventory of each board and which community members have those boards available. You may want to confirm availability and shipping costs with the order contact by email prior to sending any funds. See Contact Information Table at the end for contact email addresses
Note that these boards are being created/ordered by hobbyists and distributed to other hobbyists, without any warranty expressed or implied by the operator of the Retro PCBs wiki.
S-100 Bus Boards
| Board / Component | Stock | Price | Order Contact | Notes |
|---|---|---|---|---|
| 4MB SRAM v01 | 30 | $20 | Todd Goodman | |
| 8-bit VGA v11 | 20 | $20 | Todd Goodman | |
| 16-bit VGA v15a | 20 | $20 | Todd Goodman | |
| – Trident Adapter v15a | 20 | $5 | Todd Goodman | |
| 16MB SRAM - v6.0a | 20 | $20 | Todd Goodman | |
| —- Mezzanine Board for SRAM - V06d | 60 | $3 | Todd Goodman | |
| 16MB SRAM - V1 | 60 | $15 | Todd Goodman | |
| —-Mezzanine board for SRAM - V06C | 12 | $1 | Todd Goodman | |
| 6502 CPU board | 20 | $20 | Todd Goodman | |
| 8086 Master/Slave CPU Board | 20 | $20 | Gary Kaufman | |
| 8088 Master v2 (Marked "Version 01" on silkscreen) | 20 | $20 | Todd Goodman | |
| 68000/68010 CPU board v1.03b | 20 | $20 | Todd Goodman | |
| 68030 v1.1 | 20 | $20 | Todd Goodman | |
| 80286 v2 | 20 | $20 | Todd Goodman | |
| 80386 v2.31 | 20 | $20 | Todd Goodman | |
| 8MB OTT RAM v3a | 20 | $34 | Todd Goodman | |
| 32/64MB OTT RAM v3.11b | 20 | $26 | Todd Goodman | |
| Altair 8800 CPU Board (8080A) reproduction of original | 30 | $30 | Gary Kaufman | |
| AM9511 Math Board v1.0 | 20 | $30 | Todd Goodman | |
| Backplane (9 slot, terminated) - V4 | 20 | $15 | Todd Goodman | |
| Backplane (Antony's 18 slot, terminated) - V2 | 20 | $32 | Todd Goodman | |
| Regular Prototyping Board | $20 | |||
| Buffered Prototyping Board v3.0a | 20 | $20 | Todd Goodman | |
| Buffered Prototyping Board Mini Sea of PTH's | 30 | $32 | Todd Goodman | |
| Buffered Prototyping Board Mini Sea of PTH's | 30 | $25 | Josh Bensadon (in Canada) | |
| Bus Display v1.21 | 60 | $25 | Todd Goodman | |
| Bus Extender - V2 | 20 | $20 | Todd Goodman | |
| Bus Terminator | 20 | $20 | Todd Goodman | |
| CCS-2422E | 20 | $20 | Todd Goodman | |
| CPLD Programming Motherboard | 20 | $15 | Todd Goodman | |
| Dazzler II v2.1d | 20 | $22 | Todd Goodman | |
| – CPLDs, Programmed, for Dazzler II, One set (3 - U1, U3, and U6) | 0 | $37 for the set of three | Todd Goodman | Working to source and program more |
| – Joystick board for Dazzler II v1 (2016) | 20 | $5 | Todd Goodman | |
| Dual IDE - Version 03a | 20 | $20 | Todd Goodman | |
| Dual IDE - Version 04 | 20 | $20 | Todd Goodman | |
| FPGA 80486 SBC v2.1 | 20 | $25 | Todd Goodman | |
| FPGA v2 | 20 | $32 | Todd Goodman | |
| – FPGA Shield #0 | 20 | $8 | Todd Goodman | |
| – FPGA Shield #1 | 20 | $8 | Todd Goodman | |
| Front Panel - Full Size (reproduction of a popular classic) | 2 | ?? | Don Caprio | Looking for Beta tester |
| Full Size 80486 v15a | 20 | $36 | Todd Goodman | |
| IMSAI MPU-A CPU Board (8080A) reproduction of original | 20 | $30 | Gary Kaufman | |
| Mega 328-2560 v1.11 | 20 | $20 | Todd Goodman | |
| MSDOS Support v3a | 20 | $20 | Todd Goodman | |
| MSX VDP Video Board v05 | 20 | $20 | Todd Goodman | |
| Parallel ASCII Keyboard v02 | 20 | $20 | Todd Goodman | |
| Parallel I/O Board V2 | 20 | $20 | Todd Goodman | |
| PIC/RTC v1.1 | 20 | $20 | Todd Goodman | |
| Propeller Based Console I/O - v2.51 | 20 | $20 | Todd Goodman | |
| PDP11 CPU v2 | 20 | $20 | Todd Goodman | |
| PDP11 Support v1.01 | 20 | $20 | Todd Goodman | |
| RAM & ROM - v2.0b | 20 | $20 | Todd Goodman | |
| Raspberry Pi CPU Board v2.3 | 20 | $30 | Todd Goodman | |
| Rich Camarda's Cromemco ZPU Reproduction revB | 20 | $22 | Todd Goodman | |
| Rich Camarda's CompuPro System Support Reproduction revB2 | 20 | $22 | Todd Goodman | |
| S-100 Bus Breakout Board | 75 | $5 | Don Caprio | Board In production |
| S-100 Front Panel (aka FP Mini) | 4 | $20 | Don Caprio | |
| S-100 OPL3 V1 | 20 | $17 | Todd Goodman | |
| S-100 PC-AT Ver 02 (DOS Support Board) | 0 | $15 | Neil Breeden | |
| S-100 V2 MSX2 UTILITY Board | 9 | 15 € | Jordi Solis | Looking for Beta tester |
| Serial I/O v3.1 | 20 | $20 | Todd Goodman | |
| Serial I/O v4.2 | 20 | $20 | Todd Goodman | |
| Z-80 SBC v1.1a | 20 | $20 | Todd Goodman | |
| System Monitor Board - V3 | 40 | $20 | Todd Goodman | |
| ——TIL311 Display Board for SMB | 20 | $6 | Todd Goodman | |
| ——LED Bar Display Board for SMB | 20 | $10 | Todd Goodman | |
| ——HP5082 Display Board for SMB | 20 | $10 | Todd Goodman | |
| Z-80 FPGA v1.2 | 20 | $20 | Todd Goodman | |
| Z-80 Master v2.01 | 20 | $22 | Todd Goodman | |
| Z180 SBC v0.9 | 20 | $15 | Todd Goodman | |
| ZFDC v1.0b | 20 | $20 | Todd Goodman |
Xi 8088 Project (Sergey Kiselev)
| Board / Component | Stock | Price | Order Contact | Notes |
|---|---|---|---|---|
| Xi 8088 PCB | 20 | $25 | Todd Goodman | |
| ISA Backplane PCB | 40 | $17 | Todd Goodman | |
| ISA SVGA v1.1 PCB | 40 | $10 | Todd Goodman | |
| XT-CF-Lite PCB | 30 | $12 | Todd Goodman | |
| ISA OPL2 PCB | 40 | $10 | Todd Goodman | |
| ISA Floppy Disk and Serial Controller PCB | 40 | $10 | Todd Goodman | |
| Micro 8088 PCB | 20 | $20 | Todd Goodman | |
| ISA 8-Bit Backplane PCB | 20 | $15 | Todd Goodman | |
| SST39SF040 (512 KiB Flash) | 8 | $4 | Sergey Kiselev | Can be preprogrammed with the firmware of your choice |
Other (formerly known as "Mini") Boards
| Board / Component | Stock | Price | Order Contact | Notes |
|---|---|---|---|---|
| PPIDE | 20 | $12 | Todd Goodman | |
| PPISD | 20 | $5 | Todd Goodman | |
| AT2XTKBD | 20 | $5 | Todd Goodman | |
| SCSI2IDEv2 | 40 | $10 | Todd Goodman | |
| XT-IDE (ISA Bus) | 0 | $12 | Todd Goodman | Not sure about reordering, new version created by someone on VCF |
| XT-FDC | 0 | $12 | Todd Goodman | May reorder |
DEC (Digital) Boards (designed by Joerg Hoppe)
| Board / Component | Stock | Price | Order Contact | Notes |
|---|---|---|---|---|
| UniBone PCB | 20 | $60 | Todd Goodman | |
| UniBone I2C PCB | 20 | $10 | Todd Goodman | |
| UniProbe PCB | 20 | $40 | Todd Goodman | |
| QProbe PCB | 20 | $32 | Todd Goodman | |
| - LED Plug for QProbe | 20 | $8 | Todd Goodman | |
| KM11 Maintenance Panel PCB | 20 | $15 | Todd Goodman | |
| G7273 Diagnostics/Grant Continuity PCB | 20 | $20 | Todd Goodman | |
| DEC Flip-Chip Extender - Single PCB | 20 | $18 | Todd Goodman | |
| DEC Flip-Chip Extender - Single 5 PCB | 20 | $18 | Todd Goodman | |
| DEC Flip-Chip Extender - Dual PCB | 20 | $25 | Todd Goodman | |
| DEC Flip-Chip Extender - Dual 5 PCB | 20 | $25 | Todd Goodman | |
| DEC Flip-Chip Extender - Quad PCB | 20 | $35 | Todd Goodman | |
| DEC Flip-Chip Extender - Quad 5 PCB | 20 | $35 | Todd Goodman | |
| DEC Flip-Chip Extender - Hex PCB | 20 | $42 | Todd Goodman | |
| DEC Flip-Chip Extender - Hex 5 PCB | 20 | $42 | Todd Goodman | |
| –Connectors for Flip-Chip Extenders - ECS PN 2418-13-30 2400 Series Edge Card Connector - 18 contact pairs, .465 tail length, 30u Au | 0 | $10 | Todd Goodman | Unfortunately the quote I received from ECS is now five times the amount per connector as previously. I'll try again once things hopefully settle in the future. |
DEC (Digital) Boards (designed by Joerg Hoppe)
| Board / Component | Stock | Price | Order Contact | Notes |
|---|---|---|---|---|
| UniBone PCB | 20 | $60 | Todd Goodman | |
| UniBone I2C PCB | 20 | $10 | Todd Goodman | |
| UniProbe PCB | 20 | $40 | Todd Goodman | |
| QProbe PCB | 20 | $32 | Todd Goodman | |
| - LED Plug for QProbe | 20 | $8 | Todd Goodman | |
| KM11 Maintenance Panel PCB | 20 | $15 | Todd Goodman | |
| G7273 Diagnostics/Grant Continuity PCB | 20 | $20 | Todd Goodman | |
| DEC Flip-Chip Extender - Single PCB | 20 | $18 | Todd Goodman | |
| DEC Flip-Chip Extender - Single 5 PCB | 20 | $18 | Todd Goodman | |
| DEC Flip-Chip Extender - Dual PCB | 20 | $25 | Todd Goodman | |
| DEC Flip-Chip Extender - Dual 5 PCB | 20 | $25 | Todd Goodman | |
| DEC Flip-Chip Extender - Quad PCB | 20 | $35 | Todd Goodman | |
| DEC Flip-Chip Extender - Quad 5 PCB | 20 | $35 | Todd Goodman | |
| DEC Flip-Chip Extender - Hex PCB | 20 | $42 | Todd Goodman | |
| DEC Flip-Chip Extender - Hex 5 PCB | 20 | $42 | Todd Goodman | |
| –Connectors for Flip-Chip Extenders - ECS PN 2418-13-30 2400 Series Edge Card Connector - 18 contact pairs, .465 tail length, 30u Au | 0 | $10 | Todd Goodman | Unfortunately the quote I received from ECS is now five times the amount per connector as previously. I'll try again once things hopefully settle in the future. |
Norberto Collado's Heathkit H8/H89 Boards
Order Contact Information
| Contact | Locn | Last Updated | Username | |
|---|---|---|---|---|
| Todd Goodman | tsg <at> bonedaddy.net, tsg <at> goodmanhome.net or tacoman656 <at> gmail.com | USA | 31 Jan 2026 | tgoodman |
| Sergey Kiselev | skiselev:gmail/com (replace ':' with '@' and '/' with '.') | 28 Jul 2015 |
boardinventory.1769876103.txt.gz · Last modified: by tgoodman